AI-Based Optimal Energy Harvesting to Reduce Electromagnetic Radiation from GSM and WiFi at ATBU Yalwa Campus

Authors

  • Ishaku T. Balami Department of Electrical and Electronic Engineering, Abubakar Tafawa Balewa University, Bauchi, 740102, Nigeria https://orcid.org/0000-0003-3451-1178
  • Okpo U. Okereke Department of Electrical and Electronic Engineering, Abubakar Tafawa Balewa University, Bauchi, 740102, Nigeria
  • Ejike C. Anene Department of Electrical and Electronic Engineering, Abubakar Tafawa Balewa University, Bauchi, 740102, Nigeria
  • Hassan Aliyu Department of Electrical and Electronic Engineering, Abubakar Tafawa Balewa University, Bauchi, 740102, Nigeria

DOI:

https://doi.org/10.59461/ijdiic.v4i4.234

Keywords:

Wireless Power Transfer, Microstrip Patch Antennas, Power Density, Electric Field Strength, Magnetic Field Strength , Wireless Electromagnetic Radiation, Impedance Matching

Abstract

The tuning of LC impedance matching networks for Wireless Power Transfer (WPT) systems and the optimisation of Microstrip Patch Antennas (MPAs) are thoroughly examined in this work. A workable approach that achieves dependable convergence without requiring intricate mathematical modelling is put forth. This study examined the health hazards linked to rising mobile phone use and the positioning of mobile base stations in Nigeria's most populated regions. At the Abubakar Tafawa Balewa University (ATBU) Yelwa campus, measurements of power density, electric field strength, and magnetic field strength were made using TM-195 meter technology and OpenSignal software. Within 16.48 meters of the main coverage area, power density values were found to exceed the permitted limit of 0.001 W/m² by up to 4.81 times, posing serious health and safety risks to the local population. Additionally, it was shown that scavenging low-density RF signals from 0.5 to 3 GHz is feasible. At a resonant frequency of 1.8 GHz, optimised rectenna designs achieved peak voltages of 1.2 V and peak currents of 120 μA. The measurement setup indicates that the rectifier achieves 69.4% efficiency at +10 dBm, 20% from +5 dBm to +13 dBm, with output voltages ranging from 27.9 mV to 104.1 mV. Harvesting energy in the form of power to supply loads of the required rating allowed for a 99.88% power reduction, reducing 7,583.55 µW from the TM-195's maximum of 5810 µW to a simulated 306.38 µW. By lowering exposure to electromagnetic radiation, this optimisation improved energy efficiency and preserved operational efficacy while lowering possible health risks.

Downloads

Download data is not yet available.

References

M. V Ursăchianu, C. Lăzărescu, O. Bejenaru, and A. Sălceanu, “Assessment of human exposure to EMF generated by 5G mobile phone base stations,” IOP Conf. Ser. Mater. Sci. Eng., vol. 1254, no. 1, p. 012026, 2022, doi: 10.1088/1757-899x/1254/1/012026.

M. Aminu-Baba et al., “A compact triband miniaturized MIMO antenna for WLAN applications,” AEU - Int. J. Electron. Commun., vol. 136, no. November 2020, p. 153767, 2021, doi: 10.1016/j.aeue.2021.153767.

M. Nosrati and P. Rezaei, “Efficient integrated 5 × 2 rectenna array for low RF energy recovery,” AEU - Int. J. Electron. Commun., vol. 161, no. January, p. 154547, 2023, doi: 10.1016/j.aeue.2023.154547.

B. Bai et al., “Design of impedance matching network based on optimized real frequency algorithm,” Electron. Lett., vol. 58, no. 13, pp. 499–501, 2022, doi: 10.1049/ell2.12429.

A. Ozovehe, A. Usman, and A. Hamdallah, “Electromagnetic Radiation Exposure from Cellular Base Station: A Concern for Public Health,” Niger. J. Technol., vol. 34, no. 2, p. 355, 2015, doi: 10.4314/njt.v34i2.20.

O. D. Osahon, G. E. Okungbowa, and O. Ogboghodo, “Measurement and analysis of power density around selected global system for mobile communications (GSM) base station masts in Benin city, Edo state, Nigeria,” Adv. Mater. Res., vol. 824, pp. 161–169, 2013, doi: 10.4028/www.scientific.net/AMR.824.161.

H. Wang and K. W. E. Cheng, “An improved and integrated design of segmented dynamic wireless power transfer for electric vehicles,” Energies, vol. 14, no. 7, 2021, doi: 10.3390/en14071975.

A. Yahyaoui, A. Elsharabasy, J. Yousaf, K. Sedraoui, and H. Rmili, “MIIM-based optical log spiral rectenna for efficient IR energy harvesting,” Alexandria Eng. J., vol. 61, no. 11, pp. 8897–8909, 2022, doi: 10.1016/j.aej.2022.02.025.

I. E. Marinescu and C. Poparlan, “Assessment of GSM HF-Radiation Impact Levels within the Residential Area of Craiova City,” Procedia Environ. Sci., vol. 32, pp. 177–183, 2016, doi: 10.1016/j.proenv.2016.03.022.

S. Shen and B. Clerckx, “Joint Waveform and Beamforming Optimization for MIMO Wireless Power Transfer,” IEEE Trans. Commun., vol. 69, no. 8, pp. 5441–5455, 2021, doi: 10.1109/TCOMM.2021.3075236.

M. Rafiei, J. Boudjadar, M. P. Griffiths, and M. H. Khooban, “Deep Learning-Based Energy Management of an All-Electric City Bus with Wireless Power Transfer,” IEEE Access, vol. 9, pp. 43981–43990, 2021, doi: 10.1109/ACCESS.2021.3066300.

X. Zhang, Q. Zhou, and Y. Wang, “An Efficient Pattern Search Method,” J. Appl. Math. Phys., vol. 01, no. 04, pp. 68–72, 2013, doi: 10.4236/jamp.2013.14013.

S. Agrawal, M. S. Parihar, and P. N. Kondekar, “A dual-band RF energy harvesting circuit using 4th order dual-band matching network,” Cogent Eng., vol. 4, no. 1, pp. 1–10, 2017, doi: 10.1080/23311916.2017.1332705.

D. Colaiuda, I. Ulisse, and G. Ferri, “Rectifiers’ design and optimization for a dual-channel RF energy harvester,” J. Low Power Electron. Appl., vol. 10, no. 2, 2020, doi: 10.3390/jlpea10020011.

M. Alibakhshikenari, B. S. Virdee, L. Azpilicueta, C. H. See, T. A. Denidni, and E. Limiti, “Optimum power transfer in RF front end systems using adaptive impedance matching technique,” Sci. Rep., pp. 1–12, 2021, doi: 10.1038/s41598-021-91355-4.

M. Cheffena, “Adaptive Antenna Impedance Matching Using Low-Complexity Shallow Learning Model,” IEEE Access, vol. 11, no. June, pp. 74101–74111, 2023, doi: 10.1109/ACCESS.2023.3296459.

S. Narayanan, “A Compact Two Sleeve Microstrip Patch Rectenna System For Ambient RF Energy Harvesting,” vol. 10, no. 06, pp. 716–723, 2021.

H. Yang, X. Yuan, J. Fang, and Y. C. Liang, “Reconfigurable intelligent surface aided constant-envelope wireless power transfer,” IEEE Trans. Signal Process., vol. 69, pp. 1347–1361, 2021, doi: 10.1109/TSP.2021.3056906.

I. T. Balami and E. E. Omizegba, “Achievement of Optimum Power Transfer in Radio- Frequency Front-End Systems Through the Utilization of a Pattern Search-Based Impedance Matching Technique,” 2024 1st Int. Conf. Innov. Eng. Sci. Technol. Res., pp. 1–6, 2024, doi: 10.1109/ICIESTR60916.2024.10798157.

Z. Feng, B. Clerckx, and Y. Zhao, “Waveform and Beamforming Design for Intelligent Reflecting Surface Aided Wireless Power Transfer: Single-User and Multi-User Solutions,” pp. 1–33, 2021, doi: 10.1109/twc.2021.3139440.

M. Alibakhshikenari et al., “Improved adaptive impedance matching for RF front-end systems of wireless transceivers,” Sci. Rep., vol. 10, no. 1, pp. 1–11, 2020, doi: 10.1038/s41598-020-71056-0.

Downloads

Published

06-12-2025

How to Cite

T. Balami, I., U. Okereke, O., C. Anene, E., & Aliyu, H. (2025). AI-Based Optimal Energy Harvesting to Reduce Electromagnetic Radiation from GSM and WiFi at ATBU Yalwa Campus. International Journal of Data Informatics and Intelligent Computing, 4(4), 41–51. https://doi.org/10.59461/ijdiic.v4i4.234

Issue

Section

Regular Issue